×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which of the following is required to allow load balancing between three HSRP routers connected to the same LAN?
2.
You are troubleshooting a problem with two routers configured in a HSRP group. You intended to configure the routers so that Router A and Router B would each track their respective Fa0/1 interfaces and decrement their priorities for several VLAN groups if the tracked interface went down. However, you find that Router A is not taking over as the active device for the HSRP group on VLAN 101 when the Fa0/1 interface on Router B fails. Which command would NOT be useful for discovering the problem?
3.
Refer to the following partial output of the debug standby command on an HSRP-enabled router rtrA: Which of the following information CANNOT be gathered from the given partial output?
4.
When using auxiliary VLANs, how is a phone configured with the appropriate VLAN to join?
5.
Which VLAN trunking protocol adds four bytes to the Ethernet frames?
6.
Which IOS command configures the switch for the VTP mode that will propagate its VLAN database changes to others in the domain?
7.
Which of the following statements best describes the result of issuing the instance 3 vlans 7 command?
8.
The following commands have been issued on a Catalyst switch: Which of the following VLANs is allowed on the trunk?
9.
How long does it take for a port to transition from the STP blocking state to the forwarding state by default?
10.
Which of the following is true about CDP?